We install doors that fit perfectly—no hassle, no stress! 📞 Call 313-513-1185 for Expert Installation!
If you’re looking to replace your mobile home door, you might want her can I install a standard house store? The short answer is yes, but with modifications. Mobile home doors are typically smaller and thinner than standard residential doors, so you may need to resize the opening or adjust the door frame.
In this guide will cover :
- Difference between mobile home and standard doors
- How to measure and choose the right door
- Step-by-step guide and how to install a standard door and a mobile home
- Best door options for mobile homes
If your door is damaged, drafting, or just outdated, replacing it can improve your security, energy, efficiency, and curb appeal.
What’s the difference between mobile home doors and standard doors?
Feature | Mobile Home Door | Standard House Door |
---|---|---|
Width | 32″ to 36″ | 36″ (most common) |
Height | 74″ to 80″ | 80″ (standard) |
Thickness | 1-1/4″ to 1-3/8″ | 1-3/4″ |
Frame Type | Lightweight metal or vinyl | Solid wood or metal |
Installation | Flange-mounted | Installed in a standard frame |
Key Takeaway: standard doors are larger, thicker and heavier, which means you may need to adjust the opening of the frame in your mobile home to fit it properly.
How to measure your mobile home door
Before you buy a new door, you should get accurate measurements.
- Measure the width measure the inside of the door frame to inside the door frame not just the door slab.
- Measure the height measure from the threshold bottom of the door frame to the top.
- Check the thickness most mobile home doors are thinner than standard doors, so you may need to trim the new door or install a thicker frame.
- Determine the swinging direction does your door swing inward or outward? Mobile home doors usually swing outward.
Can you install a standard door in a mobile home?
Yes, but it’s likely that you will need to modify the door opening to fit the standard 80 inch tall 36 inch wide door.
If the door opening is too small
- Remove the old door and the frame.
- Expand the rough opening with a sawzall or reciprocating saw.
- Reinforce the frame with additional lumber for support.
If the standard door is too thick
- Use a planer or a belt sander to shave the edges off the door.
- Replace the door frame with a thicker one to accommodate the new door.
If the standard door is too heavy
- Sandra doors are heavier, so they may need a stronger hinge and reinforcement to support the weight.
Alternative options: if modifying the frame is too difficult, you need to buy a mobile home replacement door that fits perfectly with no adjustments needed.
Step-by-step guide to installing a new door in a mobile home
Remove the old door
- Use a screwdriver or drill to remove the screws, holding the door in place.
- Carefully pull out the door and frame.
- Scrape off the old cock and sealant from the edges.
Adjust the opening (if necessary)
- If using a standard door, you may need to cut the frame larger.
- If you’re using a Level and a measuring tape to ensure an even fit.
- Reinforced the opening with a wood support if necessary.
Install the new door
- Place the door into the frame and check for a snug fit.
- Secure it with larger screws for extra strength.
- Apply weather stripping to improve insulation.
Seal and finish the door
- Use caulk around the edges to prevent drafts and moisture.
- Install a new threshold to prevent water from seeping inside.
- F installing a standard door, make sure that you have new hardware that alliance properly.
Best stores for mobile homes
If you don’t want to modify your frame, consider these mobile home friendly options.
- Prehung mobile home doors these fit perfectly without resizing the frame.
- Metal insulated doors, great for energy, efficiency, and security.
- Vinyl or fiberglass doors resistant to moisture and lightweight.
- Storm doors adds an extra layer of protection against wind and rain.
Tip: always check the doors swinging direction before buying to ensure matches with your home layout.
Should you hire a pro or do DIY?
DIY installation is best for :
- If you’re comfortable using basic power tools.
- You’re installing a mobile home replacement door for easy fitting.
- You have help to lift and hold the door during installation
Hire a pro if:
- You need to cut and resize the door frame.
- If you’re installing a heavy standard door.
- If you want flawless fit and weatherproofing.
Need expert door installation? Call 313-513-1185 today.
Final thoughts
Yes, you can install a standard door on a mobile home, but it requires some modifications. If you want an easy option, consider a mobile home replacement door for a perfect fit.
A new door improves security, insulation and curb appeal so you don’t want to wait to replace yours!
Need help call 313-513-1185 for fast, professional installation.
Call now to get a professional installation at an affordable price. 📞 Call 313-513-1185 Now